Installation Instructions
Original Instructions
FLEX 5000 High-speed Counter I/O Modules
Catalog Numbers
5094-HSC, 5094-HSCXT
Summary of Changes
This publication contains the following new or updated information. This list includes substantive updates only and is not intended to reflect all changes.
Product Overview
The 5094-HSC and 5094-HSCXT high-speed counter modules count incoming pulses from pulse generators, counters, limit switches, and other devices. The modules return counts
to a controller or activates outputs to execute a specific action. Six differential inputs comprise the counters.
FLEX 5000® I/O modules use the Producer-Consumer communication model. The Producer-Consumer communication model is an intelligent data exchange between modules and
other system devices in which each module produces data without first being polled.
I/O systems are used with some Logix 5000® controllers and configured with the Studio 5000 Logix Designer® application. For more information on which Logix 5000 controllers
and Logix Designer application versions are compatible with FLEX 5000 I/O modules, see the publications listed in Additional Resources on page 13.
Topic Page
Summary of Changes 1
Product Overview 1
About the Module 4
Before You Begin 5
Install the Module 6
Install the End Cap 7
Wire the Terminal Base 7
Disconnect Wires from the Terminal Base 8
Wiring Diagrams 9
Power the System 12
Remove the Module 12
Replace the Module 13
Module Specifications 13
Additional Resources 13
Topic Page
Updated template throughout
Updated UK and European Hazardous Location Approval 3
Updated IEC Hazardous Location Approval 3
Updated Special Conditions for Safe Use 4
Updated Terminal base components 5
Updated Ground Considerations 6
Updated Module Specifications 13
To Next Page
Need help?
General
