`
Reset Drive to Defaults
1. Press the Esc button until you see on the keypad display.
2. Press the Select
button and use the Up or Down arrows or until you see the Basic
Program group
on the HIM display.
3. Press the Enter or Sel button
to enter the Basic Program group. The right digit of the last viewed
parameter in that group will flash.
4. Use the Up
or Down arrows until you see P053. If you wait one (1) second, you will notice
that the HIM display scrolls with P053 – Reset to Defaults.
Note: Rather than pressing the Up
and Down arrows to scroll through many
parameters in numerical order, you can also press Sel
button to move from digit to digit or bit to bit. The digit or bit
that you can change will flash.
Page 10 of 64
To Next Page
Loading...
Need help?
General