Installation Instructions
Original Instructions
PowerFlex 750-Series Service Cart Frames 8…10 Conversion Kit
Bulletin Numbers
20G and 21G
This publication provides basic information to disassemble the 20-750-MCART1 service cart and attach the 20-750-MPLT755T frame 8…10
conversion kit for use with PowerFlex 750-Series frame size 8…10 modules, bulletin numbers 20G and 21G.
The PowerFlex® 750-Series service cart was initially designed to handle and transport PowerFlex 755T modules that are used with PowerFlex 750-
Series products with TotalFORCE™ control. The frames 8…10 conversion kit allows the PowerFlex 750-Series service cart to be converted to a
service cart capable of removing the power modules in the PowerFlex 750-Series frame 8…10 product size.
To use the PowerFlex 750-Series frames 8…10 module conversion kit catalog number 20-750-MPLT755T, you must first follow the instructions to
unpack and stage the PowerFlex 750-Series service cart 20-750-MCART1. Some disassembly of the PowerFlex 750-Series service cart will be
required.
Personal Safety
Topic Page Topic Page
Before You Being 3 Install the Frames 8…10 Conversion Kit 8
Setup the Service Cart 5 Adjust the Service Cart 9
Service Cart Components 2 Service Cart Requirements and Safety for Power Module Removal 10
Disassemble the Service Cart and Stage for Conversion 6 Move the Power Module 11
Service Cart Frames 8…10 Conversion Kit Components 7 Store the Service Cart 12
ATTENTION: The PowerFlex 750-Series service cart (20-750-MCART1) weighs approximately 60 kg (133 lb) and requires two persons to lift.
The PowerFlex 750-Series service cart frames 8…10 conversion kit (20-750-MPLT755T) weighs approximately 32 kg (70 lb) and requires two persons to lift.
ATTENTION: Personal protective equipment is required to perform this installation. At minimum, goggles, steel toe shoes, and gloves should be used.
To Next Page
Need help?
General
