THE BASS COUPLER
This feature's name is derived from the ancient term "Basso Continuo," meaning thoroughbass.
When this tilt tab is pressed,
it
will light. Any stops
or
couplers on
in
the Pedal Division will sound from
the lowest key being played on the Great manual. This provides a pedal bass without having to actually
play the pedalboard with the feet.
In its normal setting, the Bass Coupler affects keys 1 through 24
of
the Great manual, but its range
is programmable.
~HOW
TO SET THE RANGE OF THE BASS COUPLER:
6
1.
Hold SET and press the BASS tilt tab, which will start flashing.
2. Release the
SET piston and BASS tilt tab.
3. While the
BASS tilt tab is flashing, press a key which corresponds to the highest
note the range is to extend. Any note from key 1 to key
61
may be selected.
Keys above 32 will play external MIDI devices but will not play the Pedal stops.
After the selected key has been pressed, the
BASS tilt tab will shut off.
Note: When a key is pressed to set the range, no sound will be heard even
if
stops
are on, so no disturbance will be made
if
programming during a performance.
4. To use the new range, press the
BASS tilt tab.
. :
To Next Page
Loading...
