ENABLING/DISABLING
MIDI
MASTER CHANNELS
The following MIDI channels are used to control the organ through MIDI:
Great Master Channel 12
Swell Master Channel 13
Pedal Master Channel 14
It is possible to stop the transmission
or
reception
of
MIDI information on these Master
Channels.
To disable reception
of
information on a MIDI Master Channel:
1.
Hold SET and press the bottom
of
the MIDI coupler corresponding to the channel to
be
disabled.
It
will flash. Release SET and the MIDI coupler.
2. While the coupler is flashing, press the top
of
the MIDI coupler (as
if
turning off).
It
will
stop flashing.
To enable reception
of
information on a MIDI Master Channel:
1.
Hold SET and press the bottom
of
the MIDI coupler corresponding to the channel to
be
enabled. It will flash. Release SET and the MIDI coupler.
2. While the coupler is flashing, press the bottom
of
the MIDI coupler (as
if
turning on). It
will stop flashing.
When transmission on all MIDI Master Channels is inhibited, then no stop change (MIDI
System
Exclusive stop change) is transmitted.
To disable transmission
of
information on a MIDI Master Channel:
1.
Hold SET and press the MIDI coupler corresponding to the MIDI Master Channel to
disable. It will flash. Release the MIDI coupler.
2. While the coupler is flashing, hold
SET and press the top
of
the MIDI coupler (as
if
turning off). It will stop flashing.
To
enable transmission
of
information on a MIDI Master Channel:
1.
Hold SET and press the bottom
of
the MIDI coupler corresponding to the MIDI Master
Channel to enable.
It
will flash. Release the MIDI coupler.
2. While the coupler is flashing, hold
SET and press the bottom
of
the MIDI coupler (as
if
turning on). It will stop flashing.
The send and receive status
of
all MIDI Master Channels will
be
saved in the combination action
of
the 595.
12
To Next Page
Loading...
