1.
Hold
SET
and press the MIDI coupler to be changed. The coupler will flash. Release
SET
and the MIDI coupler.
2. Press the sustain switch which is located at the left
of
the Great/Pedal Expression Pedal.
The
coupler will stop flashing.
To
change the coupler back to detected velocity, repeat steps 1 and 2 under "Velocity
Information."
The velocity status
of
the Great and Swell MIDI couplers will be stored in the
combination action
of
the organ.
CHANNEL REASSIGNMENT
All
MIDI
couplers transmit
on
fixed channels except MIDI
ON
GREAT.
To
set the transmit
channel for this coupler:
1.
Hold
SET and press the bottom
of
MIDI
ON
GT. It will flash. Release SET and MIDI
ONGT.
2. Hold piston
1,
and press any key on the Great manual between low C and tenor
D#
to
signify the desired MIDI channel. Low
Cis
Channel
1,
low
C#
is
Channel2,
etc. The
MIDI
ON
GT
coupler will stop flashing.
The
new Great MIDI Channel assignment will be stored in the combination action
of
the organ.
OCTAVE TRANSPOSE
Normally, all MIDI couplers play at standard pitch (middle C
=note
60). The Octave Transpose
parameter
may
be reset to cause any MIDI coupler to play one octave above
or
below standard pitch.
1.
Hold
SET
and press the bottom
of
the desired MIDI coupler. It will flash. Release SET
and the
MIDI
coupler.
2.
To
transpose up one octave, turn the TRANSPOSER control
to+
1, +2, +3
or
+4.
3.
To
transpose down one octave, turn the TRANSPOSER control to -1, -2, -3
or
-4.
4. Exit this mode by pressing General Cancel.
5. Return the
TRANSPOSER to the desired setting.
The
Octave Transpose status
of
each MIDI coupler will be stored in the combination action
of
the organ.
To
return a MIDI coupler to standard pitch repeat steps 1-5 and return the TRANSPOSER from
+ 1 to
0
if
returning from one octave sharp. Return the TRANSPOSER from
-1
to 0
if
returning from
one octave
flat
11
To Next Page
Loading...
