SAVING
A
COMBINATION
MEMORY
The
contents
of
any combination memory may be saved into a MIDI sequencer and later
reloaded into the organ.
To
save a memory:
1.
The
Master Clock
on
the sequencer must be ON.
2. Select the memory to be saved.
3.
Hold
SET. Start the sequencer and wait for
it
to begin recording.
4. Release
SET
to begin the transmission
of
memory information. Each piston will light as
it
is saved to the sequencer.
5.
Stop the sequencer after all pistons have been saved.
To
restore a memory from the sequencer:
1.
Select the memory to be loaded into the 595.
2. Hold SET and start the sequencer playback. Each piston will light as
it
receives memory
information.
3. Release
SET
after the final memory has been received.
RECEIVING
A
PROGRAM
CHANGE
Registrations may be selected on the organ by sending a Program Change from another MIDI
device. The following is a list
of
Program Changes the 595 will respond to
on
Channel 12:
PROGRAM CHANGE
1
2
3
4
5
6
7
8
9
10
20
31
32
WILL SELECT
piston 1
piston 2
piston 3
piston 4
piston 5
piston 6
piston 7
piston 8
piston 9
piston
10
General Cancel
memory 1
memory2
15
To Next Page
Loading...
