Radio and Television Interference
The Rodgers
595
uses and generates small amounts
of
radio-frequency (RF) energy.
The
instrument complies with the limits set for Class B digital devices. FCC Rules,
Part 15, Subpart B defme the limits for radio and television interference in a
residential installation.
Follow the installation and the use instructions
in
the manual,
or
the instrument could
potentially cause interference with some radio
or
television reception.
In
the unlikely
event this occurs, we encourage the user to
try the following corrective measures:
11
./
Turn the instrument OFF to see
if
it is the actual source
of
the
interference.
Disconnect the peripheral devices and their input/output cables one
at a time.
If
the interference stops, it is caused
by
the peripheral
device
or
its
1/0
cable .
./
Try coiling and uncoiling the instrument's power cord in different
ways.
Connect the instrument's power cord to a power outlet on a
different circuit.
Move the instrument further away from the radio
or
television
receiver .
./
Turn the radio or television receiver until the interference stops .
./
Connect the radio
or
television receiver to a different power circuit.
./
Reorient
or
move the receiver antenna further away from the
instrument. Consider installing a rooftop antenna with coaxial
cable lead-in between the antenna and receiver .
./
Consult the nearest Rodgers dealer for more information
if
the
above corrective measures
don't
remove the interference.
To Next Page
Loading...
