Preparation for Use
R&S
®
EB510
5Getting Started 4091.7338.02 ─ 01
1 Preparation for Use
This section describes the basic steps to be taken when setting up the R&S EB510
for the first time.
1.1 Specific Safety Instructions
General safety instructions
Please follow the basic safety instructions included in this documentation as
well as the instructions for setup and connection to prevent personal injury or
damage to the R&S EB510. This is of particular importance when you use the
R&S EB510 for the first time.
The following safety instructions apply in particular:
●
IEC 364
●
VDE 0100
●
DIN 57100
These safety regulations deal with the following aspects:
●
Prevention of accidents
●
Protection against overvoltage
●
Insulation of equipment
●
Grounding
●
Characteristics and laying of lines and cables
●
Provisions for operational facilities and rooms and systems of a special nature
Specific Safety Instructions
To Next Page
Loading...
