Software and Firmware Update
R&S
®
EB510
61Getting Started 4091.7338.02 ─ 01
After a successful change of the IP address, a dialog (shown below) with the option
to update the program (firmware) code appears.
Selecting "No" will reset the R&S EB510, such that the new IP address will take
effect.
Selecting "Yes" will continue with the update of program (firmware) code as defined
in the configuration file. Refer to chapter 4.3, "Receiver Firmware Update for EB510
without front control panel", on page 48 for details.
4.5.2 Using GUI (EB510 with front control panel or Remote
Access GUI)
The IP address of the R&S EB510 is needed during the GUI Installation for Remote
Access. This can be obtained from the front panel of the EB510 with front control
panel with the key sequence SETUP -> "Config" -> "Network". Refer to the Oper-
ating Manual for more details.
Changing the IP Address
To Previous Page
Loading...
