Rohde & Schwarz EB510 - Changing the IP Address; Using Update32 Tool

Software and Firmware Update
R&S
®
EB510
59Getting Started 4091.7338.02 ─ 01
4.5 Changing the IP Address
4.5.1 Using Update32 Tool
The IP address of the R&S EB510 can be changed using the "Update32" tool. By
default, the R&S EB510 is shipped with DHCP enabled.
Refer to "Retrieve Update32" under chapter 4.3, "Receiver Firmware Update for
EB510 without front control panel", on page 48 to read the steps for retrieving and
running the "Update32" tool.
Starting the procedure
Run Update32 and allow access if there are security warnings. If a configuration
is not loaded previously, refer to "Selecting the configuration file" under chapter 4.3,
"Receiver Firmware Update for EB510 without front control panel", on page 48 to
select an appropriate configuration file. Select "Config” -> “LAN Settings via Ether-
net" as shown below:
Selecting the target R&S EB510
The R&S EB510, for which you want to update the IP address, needs to be switched
on. Make sure there is a LAN connection between the R&S EB510 and the PC. After
a short period, a new entry will be shown in the list of targets as shown in the figure
below. Select the appropriate target and press the "Start" button.
Changing the IP Address