Software and Firmware Update
R&S
®
EB510
58Getting Started 4091.7338.02 ─ 01
Start the Remote Access GUI via "Start" -> "Programs" -> "R&S EB510 GUI". The
following dialog may appear due to the Windows Firewall. Click on "Unblock" to
allow the traffic to/from the R&S EB510
As a last step, you may have to change the Windows Firewall settings to enable the
network traffic of the R&S EB510 GUI. For this reason, start the GUI via "Start" ->
"Programs" -> "R&S EB510 GUI". When the GUI is displayed, the following dialog
may also appear.
Click "Unblock" and the Windows Firewall is set to enable the network traffic of the
R&S EB510 GUI.
GUI Installation for Remote Access
To Next Page
Loading...
