Software and Firmware Update
R&S
®
EB510
48Getting Started 4091.7338.02 ─ 01
Updating the EB510 without front control panel
The EB510 without front control panel cannot be updated with this method.
In order to update the receiver firmware of a EB510 without front control panel,
you will need the Update32 tool. The method of updating by using the
Update32 tool is described in chapter 4.3, "Receiver Firmware Update for
EB510 without front control panel", on page 48.
Remote GUI on Notebook / desktop PC
If you want to install the GUI for use on a notebook or desktop PC, you should
follow the procedure described in chapter 4.4, "GUI Installation for Remote
Access", on page 54.
If the R&S EB510 cannot reboot
Due to the fact that the R&S EB510 also can be updated using the Update32
Tool (see "Updating the EB510 with front control panel" on page 53), there
is a chance that the R&S EB510 cannot reboot. Follow the steps described
in "If the R&S EB510 cannot reboot" on page 54 to deal with this problem.
4.3 Receiver Firmware Update for EB510 without
front control panel
This model requires a different update method which makes use of the LAN inter-
face of the R&S EB510 (X7 on the rear panel). The method uses the "Update32"
tool, which runs under Windows NT, Windows 2000 and Windows XP.
Retrieve Update32
The firmware required for the update can be retrieved from either one of the loca-
tions mentioned at "CD-ROM and Downloads" on page 40.
Click on Firmware Update Program and File Explorer will be launched into
the directory Update32XP. The Update32 tool can be installed by clicking on
Setup. If your browser does not launch File Explorer, you should launch it
Receiver Firmware Update for EB510 without front control panel
To Next Page
Loading...
