Software and Firmware Update
R&S
®
EB510
47Getting Started 4091.7338.02 ─ 01
Flash erase and update
While updating a R&S EB510, portions of the flash memory will be erased.
This erase process may take up to two minutes, after which the new firmware
will be loaded. This will usually take about one minute. The update progress
is visualized by means of notification dialogs and progress bars.
Then, while the receiver resets, the GUI will be updated. The GUI runs on a dedi-
cated processor (IPS1) and has its own operating system. This processor also
needs to reboot once the update completed.
At the end of the process, when the dialog below is shown, press ENT to reboot.
Now both the receiver firmware and the GUI are updated with the latest version.
This can be verified after reboot by following the steps shown in chapter 4.1,
"Retrieve Firmware and GUI Versions", on page 39.
If update procedure fails.
If the update procedure fails, simply switch off the R&S EB510 and restart the
update procedure.
Receiver Firmware and GUI Update for EB510 with front control panel
To Next Page
Loading...
