Software and Firmware Update
R&S
®
EB510
49Getting Started 4091.7338.02 ─ 01
manually and navigate to the Update32XP directory on the CD-ROM where you
can run Setup.
Flash erase and update
While updating a R&S EB510, portions of the flash memory will be erased.
This erase process may take up to two minutes, after which the new firmware
will be loaded. This will usually take about one minute for the R&S EB510.
The update progress is visualized by the progress bar of the "Update32" tool.
Interrupted Power to R&S EB510
Switching off the power supply during the update procedure is not recom-
mended but will not harm the R&S EB510 as the "bootprog" is still available
for subsequent firmware update of the system.
4.3.1 Preparations
Checking the R&S EB510 firmware version number
Refer to the section chapter 4.1, "Retrieve Firmware and GUI Ver-
sions", on page 39 to obtain the current version of the firmware in the R&S EB510,
if necessary.
System requirements
For a firmware update you need:
●
An IBM-compatible PC running Windows NT, Windows 2000 or Windows XP
with LAN interface.
●
A standard LAN cable with RJ45 connectors.
●
The "Update32" tool for Windows XP requires a WinPcap installation. Installing
the latest version of the tool will also install the version of WinPcap that is com-
patible with the version of the tool (please note the disclaimer and the information
in WinPcap's "About" box).
Receiver Firmware Update for EB510 without front control panel
To Next Page
Loading...
