Software and Firmware Update
R&S
®
EB510
55Getting Started 4091.7338.02 ─ 01
4.4.2 Installation Procedure
Execute the Remote Access GUI installer by clicking on GUI Installation for
Remote Access on the html menu. Allow access if there are security warnings.
Uninstalling an earlier version of the GUI
If an earlier version of the GUI exists, it must be uninstalled before the installation
of a new GUI can proceed. A dialog will appear first, which requests to uninstall this
earlier version:
Click OK and wait for the uninstall to proceed.
Once uninstall is completed, the installation can go ahead. The first step is to key-
in the IP address and port number of the R&S EB510. You can find it under "Current
IP Address" and "Current Port" after opening the "Network Configuration" dialog
(SETUP > "Config" > "Network") on the front panel.
GUI Installation for Remote Access
To Next Page
Loading...
