Software and Firmware Update
R&S
®
EB510
53Getting Started 4091.7338.02 ─ 01
Completing the update
After the update is completed, close the dialog by clicking on the "OK" button. The
R&S EB510 will restart automatically.
If update procedure fails.
If the update procedure fails, simply switch off the R&S EB510 and restart the
update procedure.
Updating the EB510 with front control panel
The EB510 with front control panel can also be updated using the method
with the Update32 tool. Please take note that this method cannot update the
GUI. This might cause version conflicts between receiver firmware and GUI.
For updating the EB510 with front control panel, use the method described in
chapter 4.2, "Receiver Firmware and GUI Update for EB510 with front control
panel", on page 40.
Receiver Firmware Update for EB510 without front control panel
To Next Page
Loading...
