Software and Firmware Update
R&S
®
EB510
52Getting Started 4091.7338.02 ─ 01
Starting the update
●
Click on the "Update" button:
and the following dialog will appear.
● Switch ON the power to the R&S EB510 ("target") to be updated. After a short
period a new entry will be shown in the list of targets as shown in figure below.
●
Select the desired target and click the "Start" button.
Updating process
The following dialog appears when the update starts. In the process, the flash is
being erased and then the new firmware is loaded into the flash.
Receiver Firmware Update for EB510 without front control panel
To Next Page
Loading...
