Rohde & Schwarz ETL 2112.0004.13 - Keys for Changing Softkey Menus; Keys for Operating Softkeys

Interfaces and Connectors
R&S
®
ETL
19Getting Started 2118.4130.02 ─ 04
PRINT key
Displays the softkeys of the print menu for:
●
Customizing the screen printout.
●
Selecting and configuring the printer.
HELP key
Displays the context-sensitive help.
MODE key
Opens a dialog box to change between measurement modes.
MENU key
Displays the highest softkey menu level of the current measurement mode.
5.1.3 Keys for Operating Softkeys
See (3) in Figure 5-1.
The label (function) of the keys is displayed on the left as so-called softkeys. The soft-
keys change dynamically according to the current selection.
5.1.4 Keys for Changing Softkey Menus
See (4) in Figure Figure 5-1.
The softkey menus differ according to the selected measurement mode. Here, the soft-
keys of the default "Spectrum Analyzer" mode are described roughly.
For detailed information on the softkey menus of all measurement modes, refer to the
user manual or the help.
[FREQ] key
Displays the softkeys of the frequency menu for the following settings:
●
Center frequency for the frequency range under consideration
●
Start and stop frequencies for the frequency range under consideration
●
Frequency offset
●
Signal track function
[SPAN] key
Displays the softkeys of the span menu. Used to set the frequency span to be ana-
lyzed.
Front Panel