Interfaces and Connectors
R&S
®
ETL
28Getting Started 2118.4130.02 ─ 04
CCVS OUT
Used in "TV Analyzer/Receiver" mode:
●
Video source 75 Ω CCVS 1 Vpp
– Analog TV: demodulated video signal
With the Video Generator option (R&S ETL-K203) installed and the video gen-
erator enabled: Video generator output 75 Ω CCVS 1 Vpp
– Digital TV, only with R&S ETL-B281: decoded video signal
●
Audio source for radio (FM Stereo / FM Mono, R&S ETL-K110). Provides one of
the following demodulated signals: MPX, pilot, RDS/DARC carrier, or digital audio
in the AES/EBU format.
AUDIO
Audio source 1/L output 600 Ω balanced.
Audio source 2/R output 600 Ω balanced.
5.2.2 DC Power Supply (B230)
Optional; installed in slot 2, see Figure 5-2.
Used as alternative power supply. For the ratings of the power supply, refer to the data
sheet. The connector is supplied with the accessories.
Table 5-1: Pin assignment
Pin Description
1 Plus
2 Ground
3 Not used
Rear Panel
To Next Page
Loading...
