Rohde & Schwarz ETL 2112.0004.13 - Keypad; RUN Key

Interfaces and Connectors
R&S
®
ETL
21Getting Started 2118.4130.02 ─ 04
[MKR->] key
Displays the softkeys of the marker -> menu for:
●
Using for search functions of the measurement markers (maximum/minimum of the
trace).
●
Assigning the marker frequency to the center frequency.
●
Assigning the marker level to the reference level.
●
Restricting the search area.
●
Characterizing the maximum points and minimum points.
[MEAS] key
Displays the softkeys of the measurement menu to perform advanced measurements:
●
Time domain power
●
Channel, adjacent channel and multicarrier adjacent channel power
●
Occupied bandwidth
●
Signal statistics: amplitude probability distribution (APD) and cumulative comple-
mentary distribution function (CCDF)
●
Carrier to noise spacing
●
AM modulation depth
●
Third-order intercept point (TOI)
●
Harmonics
[LINES] key
Displays the softkeys of the lines menu to configure the display lines and limit lines.
[TRACE] key
Displays the softkeys of the trace menu to configure the measured data acquisition and
the analysis of the measurement data.
5.1.5 RUN Key
See (5) in Figure 5-1.
Starts a new measurement.
5.1.6 Keypad
See (6) in Figure 5-1.
Used to enter alphanumeric parameters:
●
Alphanumeric keys
Enters numbers and (special) characters in edit dialog boxes.
For details, refer to the user manual, chapter "Operating Concepts", or the help.
●
Decimal point
Front Panel