Rohde & Schwarz NGMO1 - Page 70

Power Supply NGMO IEEE Commands
5-18 4.00 / 07-2004
Com-
mand
Parameter Par. value Description Def. SCPI
MIN 0
DEFault 15
MAX 15
:VOLTage [:LEVel] [:IMMedi-
ate]
[:AMPLi-
tude]
<CHAR_VAL> or
<NUM_VAL>
Sets voltage amp-
litude in 1 mV
steps
0
0.000 0 Volt
15.000 15 Volt
MIN 0 Volt
* DEFault 0 Volt
MAX 15 Volt
DISPlay Sets LCD to main
display
:VOLTage [:LEVel] [:IMMedi-
ate]
[:AMPLi-
tude]?
<CHAR_VAL> Queries voltage
amplitude
Results:
0.000 <=
NUM_VAL <=
15.000
MIN 0
DEFault 0
MAX 15
:CURRent [:LIMit] [:VALue] <CHAR_VAL> or
<NUM_VAL>
Sets current limit
in Amps (max.
2.5A on voltages
above 5V)
2
0.000 0.000A
5.000 5.000A
MIN 0.000A
* DEFault 2.000A
MAX 5.000A
DISPlay Sets LCD to main
display
:CURRent [:LIMit] [:VALue]? <CHAR_VAL> Queries current
limit
Results:
0.000 <=
NUM_VAL <=
5.000
MIN 0
DEFault 5
MAX 5
:CURRent [:LIMit] :MAXSet-
ting
<CHAR_VAL> or
<NUM_VAL>
Sets maximum
settable current
limit
5
0.000 0.000A
5.000 5.000A
MIN 0.000A
* DEFault 5.000A
MAX 5.000A