Sample Application
R&S
®
SFE100
43Getting Started 2112.4122.62 ─ 13
7. Press OK to confirm your entry.
8. Press the BACK key to exit the work view and get back to the tree.
Setting the modulation parameters and selecting the transmission standard
Depending on the R&S
SFE100 model, the signal source and the transmission stan-
dard are fixed to "DTV" and "DVBC" under "MODULATION".
Selecting the transport stream input and setting the DVB-C transmission param-
eters
1. Using the UPARROW/DNARROW keys, select the "DIGITAL TV" menu.
2. Press the OK or RIGHTARROW key.
The tree is expanded and the "DIGITAL TV" submenu is displayed.
3. Select the "INPUT SIGNAL" submenu and confirm your entry with OK.
The work view is displayed.
4. Select the "EXTERNAL" source.
a) Using the UPARROW/DNARROW keys, select the "SOURCE" field.
b)
Press OK to open the list.
c) Using the UPARROW/DNARROW keys, select "EXTERNAL".
d) Press OK to confirm your entry.
5. Select the "ASI 1" input.
a) Using the UPARROW/DNARROW keys, select the "INPUT" field.
b) Press OK to open the list.
c) Using the UPARROW/DNARROW keys, select "ASI 1".
d) Press OK to confirm your entry.
6. Make sure that the "STUFFING" field in the work view is set to "ON".
This ensures that the incoming transport stream will be adapted to the proper data
rate of the coder. The data rate of the coder will depend on the transmission
parameters. The data stream is padded with null packets to allow adaptation to the
transmission parameters.
7. Press the BACK key to exit the work view and get back to the tree.
8. Select the "CODING" submenu and confirm your entry with OK.
The work view is displayed.
Using Display and Keys on the Front Panel
To Next Page
Loading...
