Operating the Instrument
R&S
®
RTE
100Getting Started 1326.1026.02 ─ 08
2. Enter the text as you would on a normal keyboard.
●
To enter a series of capital characters, tap "Caps".
To enter one capital character, tap "Shift".
● To use the currently defined value, tap "Cur". This is the value that was
used before the keyboard was displayed.
● The arrow buttons move the cursor left or right.
● "Bksp" deletes the last character before the cursor.
3. Tap "Enter" to complete the entry.
To enter numeric data in a dialog box with navigation controls
1. To navigate to the entry field, press the [⇤ Field] and [⇥ Field] keys.
2. To change the value with a small step size, turn the rotary knob.
Alternatively, press the [⇧] and [⇩] keys for a larger step size.
If you edit numeric data in tables, the entry field must be in edit mode. To activate
the edit mode, press ENTER, or the [☑] key, or the navigation rotary knob.
6.11 Messages
Status messages of the instrument are displayed for a few seconds. Then they
are saved in a message box in the upper right corner of the screen. By default,
the message box is closed. You can open it to read the messages and to delete
them.
Messages
To Next Page
Loading...
