Trying Out the Instrument
R&S
®
RTE
69Getting Started 1326.1026.02 ─ 08
5.12 Saving Data
After a measurement with the R&S R
TE, you can save the resulting waveform
data for further evaluation or comparison. You can also save measurement
results, and device settings to repeat or restore previous measurements.
●
"Saving waveform data" on page 69
●
"Saving data of an acquisition series" on page 70
●
"Saving measurement results" on page 70
●
"Saving and restoring device settings" on page 71
Saving waveform data
1. Press the [FILE] key on the front panel (in the SETUP area on the left).
2. Select "Waveform".
3. Check the "Source".
4. Set "Scope" to "Full Waveform".
Tip: If a cursor, zoom or measurement gate is defined, you can use these set-
tings to export only a part of the waveform.
5. Under "Save to file", tap "Save As".
6. The file selection dialog box shows the default storage directory:
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\
RefWaveforms
7. Tap the keyboard icon on the right of the "File Name" field.
8. Enter W
aveform1 on the online keyboard.
9. Tap "ENTER" to close the online keyboard.
10. Select the file type: "*.bin".
11. Tap "Save".
The waveform data is saved to the files Waveform1.Wfm.bin and
Waveform1.bin in the selected directory.
Saving Data
To Next Page
Loading...
