Trying Out the Instrument
R&S
®
RTE
40Getting Started 1326.1026.02 ─ 08
The dialog box turns into a mini box that contains only the "Wfm Arithmetic"
setting.
5. Select Envelope and check the waveform.
The instrument sets the "Decimation"
type automatically to Peak detect to dis-
play the correct envelope waveform.
6. Select Average and check the waveform.
7. Tap the
"Maximize" icon in the mini dialog box.
The complete
"Acquisition" dialog box is restored.
8. Close the dialog box by tapping
.
5.3 Changing the W
aveform Scaling and Position
As you can see on the y-axis of the display, the calibration signal has a vertical
offset of about 500 mV. The value can differ.
This value is also indicated in the signal icon for channel1 (3rd row). If you press
the [Ch1] key, the "Vertical" settings dialog box also displays the "Offset" value.
The offset is the DC component of the signal.
Changing the Waveform Scaling and Position
To Next Page
Loading...
