Trying Out the Instrument
R&S
®
RTE
70Getting Started 1326.1026.02 ─ 08
Saving data of an acquisition series
1.
Press the [FILE] key on the front panel.
2. Select "Waveform".
3. Set the export scope of the waveform:
a) Check the "Source".
b) Set "Scope" to "Full Waveform".
c) Tap "Data logging" to enable export all waveforms of a running acquisition.
d) Enter "Acq count" = 10, the number of subsequent waveforms that the
instrument acquires and saves.
4. Tap "Start Export" to save the waveforms to file. You can change the filename
in
"Save to file".
Saving measurement results
1. Perform a measurement as described in Chapter 5.6.2, "Performing Automatic
Amplitude Measurements", on page 51.
2. Press the [FILE] key on the front panel.
3. Select "Numeric results".
Saving Data
To Next Page
Loading...
