Trying Out the Instrument
R&S
®
RTE
53Getting Started 1326.1026.02 ─ 08
9. Select "Fall time".
10.
Under "Statistics", tap "Enable".
11. Close the "Measurements" dialog box and check the results.
12.
To see all results, drag up the border of the results tab.
13. Close the "Measurement Results" box.
5.6.3 Performing and Configuring the Quick Measurement
A set of up to eight different measurements on one source can be performed at
once, simply by tapping the "Quick measurement" toolbar icon. The results are
displayed in a result box. You can configure the measurement types to be inclu-
ded in quick measurement. This way, repeating measurements are performed
very quickly.
In the following example, you start a quick measurement and change the Quick-
Meas configuration.
1. Press [AUTOSET].
2. Tap the "Quick measurement" icon on the toolbar.
Showing Basic Measurement Results
To Next Page
Loading...
