Trying Out the Instrument
R&S
®
RTE
61Getting Started 1326.1026.02 ─ 08
4. Tap the "Source1" icon and select Ch1.
5.
Tap the "Operator" icon and select Rescale.
6. For "a", enter the vertical scaling factor, e.g. 4.
7. Under "b", enter the vertical position offset, e.g. 2.
Look at the lower part of the dialog box and note that the instrument adjusts
the "Vertical scale" and "Vertical offset" of the math waveform automatically.
8. Tap "Enable" to display the first math waveform.
The original and the rescaled waveforms are displayed.
9. Close the "Math" dialog box.
10. To remove the math waveform, do one of the following:
●
Tap the "Delete" icon and then the math waveform.
● Minimize the math waveform by tapping the signal icon. Then close the
signal icon
Performing Mathematical Calculations
To Next Page
Loading...
