Preparing for Use
R&S
®
RTP
19Getting Started 1337.9946.02 ─ 05
After connecting an additional monitor or projector to the instrument, configure it
for usage. The relevant settings are Windows settings but you can configure the
displays directly in the instrument setup.
1. Check the input type of the monitor or projector. Make sure to select the cor-
rect cable. To use a VGA monitor, you need an active DVI-D to VGA adapter.
2. Press the [Setup] key.
3. Select the "System" tab.
4. Tap "Display / Monitors".
5. To show the instrument's display content only on the external monitor, select
"Projector only".
To show the instrument's display content on both the oscilloscope and the
external monitor, select "Duplicate".
The touchscreen of the R&S RTP has a screen resolution of 1280 x 800 pixel.
Most external monitors have a higher screen resolution. If the screen resolution of
the monitor is set higher than the instrument's resolution, the application window
uses a 1280 x 800 area of the monitor display. For full screen display, adjust the
monitor's screen resolution using "Additional display settings".
Connecting External Devices
To Next Page
Loading...
