Rohde & Schwarz SMAB-K24 - Configure Trigger

Improving Level Performance
R&S
®
SMA100B
248User Manual 1178.3834.02 ─ 05
Pulse Power - Pulse Data Analysis
Selects which pulse power parameters are indicated in the diagram (pulse data view
only).
Top / Base Power ← Pulse Power - Pulse Data Analysis
Indicate the pulse top and base level of the analyzed signal in dBm.
Remote command:
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:PULSe:BASE? on page 492
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:PULSe:BASE:DISPlay:
ANNotation[:STATe] on page 493
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:PULSe:TOP? on page 492
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:PULSe:TOP:DISPlay:
ANNotation[:STATe] on page 493
Distal / Mesial / Proximal Power ← Pulse Power - Pulse Data Analysis
Display the absolute power values of the medial, low and high reference level in dBm.
Remote command:
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:LREFerence? on page 492
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:LREFerence:DISPlay:
ANNotation[:STATe] on page 493
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:HREFerence? on page 492
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:HREFerence:DISPlay:
ANNotation[:STATe] on page 493
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:REFerence? on page 492
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:REFerence:DISPlay:
ANNotation[:STATe] on page 493
Configure Trigger
Access:
1. Select "Clk Syn/Power Sens" > "NRP Power Analysis".
2. Select "Configure" > "Configure Measurement".
3. Set "Mode" > "Time".
4. Select "Configure Sensors" > "Trigger..."
Using Power Sensors