Rohde & Schwarz SMAB-K24 - General Settings

List and Sweep Mode
R&S
®
SMA100B
183User Manual 1178.3834.02 ─ 05
6.6.1 General Settings
Access:
► Select "Sweep" > "List mode".
In the "General" tab, you can configure the trigger and dwell time modes for list
processing and activate signal generation.
Settings
State ...........................................................................................................................183
Current Index ............................................................................................................. 183
Mode........................................................................................................................... 184
Dwell Time Mode.........................................................................................................184
Global Dwell Time....................................................................................................... 184
Trigger Slope...............................................................................................................184
Reset ..........................................................................................................................185
Execute Single............................................................................................................ 185
State
Activates the list mode and processes the currently selected list.
Note: Active sweep mode deactivates other sweeps or lists and vice versa.
Remote command:
[:SOURce<hw>]:FREQuency:MODE on page 591
Current Index
Sets the list index for list processing in "Step" mode. In the other modes, the index indi-
cates the current step.
Remote command:
[:SOURce<hw>]:LIST:INDex on page 617
List Mode Settings