Rohde & Schwarz SMAB-K24

To Next Page

To Previous Page

List and Sweep Mode

R&S

SMA100B

184User Manual 1178.3834.02 ─ 05

Mode

Selects the mode for list processing.

For detailed information on the sweep modes and the triggering, see Chapter 6.1, "Sig-

nal Generation and Triggering in the Sweep and List Modes", on page 156.

"Auto"

Generates the signal by processing the frequency/level value pairs of

the list from the beginning to the end.

The list steps are performed automatically, controlled by the dwell

time. If you switch from any mode to "Auto", signal generation always

starts at the top of the list.

"Single / Extern Single"

Generates the signal by processing the frequency/level value pairs of

the list once from the beginning to the end after a trigger event.

The list steps are performed automatically, controlled by the dwell

time. If one cycle is completed, the instrument waits for the next trig-

ger event.

"Step / Extern Step"

Generates the signal by processing the frequency/level value pairs of

the list step-by-step, manually triggered.

Remote command:

[:SOURce<hw>]:LIST:TRIGger:SOURce on page 619

[:SOURce<hw>]:LIST:MODE on page 618

Dwell Time Mode

Selects either variable dwell times or a fixed dwell time to perform signal generation in

list mode.

"Global"

Uses the same dwell time for all lists steps, set with Global Dwell

Time.

"From List"

Uses the dwell times from the list.

You can define the dwell time for each frequency/level value pair indi-

vidually, see Chapter 6.7, "List Editor", on page 188.

Remote command:

[:SOURce<hw>]:LIST:DWELl:MODE on page 615

Global Dwell Time

Sets the dwell time for Dwell Time Mode > "Global".

Note: In case of considerable overrun conditions, the R&S SMA100B turns off the list

mode.

Rohde & Schwarz SMAB-K24 - Page 186