Remote Control Commands
R&S
®
SMA100B
540User Manual 1178.3834.02 ─ 05
[:SOURce<hw>]:PULM:TRAin:DEXChange:SELect <Filename>
Selects the ASCII file for import or export, containing a pulse train list.
Parameters:
<Filename> string
Filename or complete file path; file extension can be omitted.
Example: See "Pulse Train Data Exchange" on page 537.
Manual operation: See "Select Source/Select ASCII Destination" on page 95
[:SOURce<hw>]:PULM:TRAin:DEXChange:EXECute
Usage:
Event
Manual operation: See "Import / Export" on page 95
Executes the import or export of the selected list file, according to the transfer direction
set with command [:SOURce<hw>]:PULM:TRAin:DEXChange:MODE.
13.16.2 Avionic Standards Subsystems
Option: see Chapter 5.1, "Required Options", on page 110.
The following subsections describe all commands for avionic standard modulation of
the RF signal. Divided into separate avionic subsystem command sections, you can
configure ADF, ILS and VOR modulation.
Programming examples are given for general configuration and avionic standard-spe-
cific configuration tasks.
Placeholder <Subsystem>
To simplify the description of the remote control commands, the placeholder
<Subsystem> is introduced. Depending on the avionic standard used as an entry
standard, replace this placeholder <Subsystem> with for example SOURce:ADF for
ADF.
The replacement of the place holder <Subsystem> is mandatory, i.e. remote control
commands containing this placeholder are not recognized and accepted by the instru-
ment.
SOURce Subsystem
To Next Page
Loading...
