Rohde & Schwarz SMAB-K24 - Page 597

Remote Control Commands
R&S
®
SMA100B
595User Manual 1178.3834.02 ─ 05
Parameters:
<Center> float
Range: 300 kHz to RFmax
Increment: 0.01 Hz
*RST: 300E6
Default unit: Hz
Example: See Example "Setup an RF frequency or power sweep"
on page 643
Manual operation: See " Center Frequency " on page 176
[:SOURce<hw>]:FREQuency:SPAN <Span>
Sets the sapn of the frequency sweep range.
See Chapter 6.2.1, "Correlating Parameters in Sweep Mode", on page 164.
Parameters:
<Span> float
Full freqeuncy range
Increment: 0.01
*RST: 400E6
Example: See Example "Setup an RF frequency or power sweep"
on page 643
Manual operation: See "Span" on page 176
[:SOURce<hw>]:FREQuency:STARt <Start>
Sets the start frequency for the RF sweep.
See Chapter 6.2.1, "Correlating Parameters in Sweep Mode", on page 164.
Parameters:
<Start> float
Range: 300kHz to RFmax
Increment: 0.01Hz
*RST: 100 MHz
Example: See Example "Setup an RF frequency or power sweep"
on page 643
Manual operation: See " Start Frequency/Stop Frequency " on page 176
[:SOURce<hw>]:FREQuency:STOP <Stop>
Sets the stop frequency range for the RF sweep.
See Chapter 6.2.1, "Correlating Parameters in Sweep Mode", on page 164.
SOURce Subsystem