ROJ SUPER ELF X3 - Duration; Force

SUPER ELF X3
–
Dornier
12
• Recommended setting:
2
it gives a
low reduction of the end
insertion tension peek.
(The yarn speed reduction at the
arrival
is very low).
3
it gives a good reduction of the en
d
insertion tension peek.
(The yarn speed reduction at the
arrival
is low).
4
it gives a very good reduction of the
end
insertion tension peek. The yarn speed
reduction is
very high and the arrival is
very irregular).
Note:
Use the
"1"
and
"5"
values only in extreme cases:
1
-
when the important is to avoid to slow dow
n the yarn at the arrival. (The
reduction of the
end insertion tension peak will be very low).
5
-
to reduce the end insertion tension peek
as much as possible. (The yarn
speed reduction
is very high and the arrival is very irregular).
Duration
This parameter set the duration of braking function.
• Possible setting:
0
the fork reach braking positio
n at same time when the
electromagnet pin stops the yarn at
end of insertion
1
minimum braking anticipation
2
low braking anticipation
3
middle braking anticipation
4
high braking anticipation
5
maximum
braking anticipation
• Recommended setting:
0, 1, 2
for
filament yarns
2, 3, 4, 5
for
fiber yarns
and
wool
Force
This parameter allows the user to choose between 5 force values:
• Possible setting:
0
minimum braking force
1
low braking force
2
middle braking force
3
high braking force
4
maximum braking force
• Recommended setting: Increase the braking force according to yarn size (Yarn count)