ROJ SUPER ELF X3 - Reserve Loading (Full threading, only with funnel); Weft Reserve Repair (Half threading)

SUPER ELF X3
–
Dornier
18
Reserve loading
(Full threading, only with funnel)
1.
Press the start push
-
button
1
on the side of the feeder for more than 3 seconds: the
Electromagnet pin goes up and the Winding Disc automaticall
y
moves to the threading
position.
2.
Release a few coils from the pack
age and keep the yarn end near the input
threading
eyelet, than press the full threading button
4
to thread the weft through the
feeder body out to
the pulsar (if the old reserve is still on the spool body it will be
automatically blown out).
3.
Press the key in the front of the feeder a second time: the Electromagnet goes
down and
the Feeder loads the reserve.
Weft reserve repair
(Half threading)
If during the Feeder operation, a weft breakage occurs at Feeder's entry, proceed as
follows:
1.
Release a few coils from the package and keep the yarn end near the input
threading
eyelet, than press the half threading button
3,
so that the weft is blown to the
output of the
winding disk without affecting the existing reserve on the Spool Body. Thi
s
operation allows
the weft to be knotted to the existing reserve.
2.
Press the start push
-
button
1
on the front of the feeder in order to reset the weft
breakage
error. The feeder will restore the complete weft reserve.