Roland Alpha Juno-2 - Naming the Tone Colors Oo

9. Naming the Tone Colors
You can write a name (within 10 letters) to each
tone color, or rename it.
<OPERATION>
@ Call the tone color which you wish to
rename.
@ Push the Name Button ®.
The Display ® will respond with:
Example ¥
Cursor Tone Name
@) Keep pressing the Name Button ® until
the cursor comes under the letter to be
changed.
The cursor moves one letter rightward each time
the Name Button is pressed. When the cursor
reaches the right end, it goes back to the beginning.
@ Change the name by using the a Dial @.
The available letters for naming are as follows.
(Space) fayppen)
(Smali Letters)
© Repeat the steps @) @ as many times as
necessary.
30
© If the tone color to be written is in the
Memory group, set the Memory Protect
Switch to the OFF position, and if it is in
the Cartridge group, set the Protect Switch
on the cartridge to the OFF position.
@ While holding the Write Button ® down,
select the tone color to be written by
pushing the relevant Group Selector But-
ton @, the Bank Selector Button ® and
the Number Selector Button ®.
The Display @® will change to:
Exampie W Renaming M-11
While holding
the Write
Button ®
down.
Cc Push the
ursor Group Selector
Tone Color Button
to be renamed “MEMORY”.
Push the
Cursor Bank Selector
Button [7].
Push the
Cursor Number Selector
Button [7],
New Name
Return the Memory Protect Switch ® or
the Protect Switch on the cartridge to the
ON position.
* Taking the operation @ will automatically write
the tone color selected in the step (). So if you
do not change the tone color but only the tone
name, assign the same tone color you called in
the step ©.
* When renaming the tone color in the Cartridge,
the position of the Memory Protect Switch @
has no effect.