Roland CD-2i

55
Advanced UsesRecording Listening Deleting Creating a CD Editing an SD Appendices
Convenient
Functions
Information
/ Display
Checking /
Preparations
Recording a record
Here’s how to record the sound of a record.
You can connect a record player directly to the CD-2i. If your record player has a phono
equalizer, refer to “Recording a cassette or MD” (Page 52).
* If you encounter a problem with noise or distortion, see “The recorded sound is noisy or
distorted” (Page 130).
4
Connect your audio device (e.g., cassette deck) to the CD-2i’s LINE/
PHONO IN jacks.
Use audio cables to connect the CD-2i’s LINE/PHONO IN jacks to the output jacks of
your audio device (e.g., cassette deck).
fig.connect-record-e.eps
* The grounding wire from your record player should be connected to the ground terminal on the
side of the CD-2i.
5
Press the [MENU] button to access the menu screen and select “LINE/
PHONO Input.“
fig.menu-overdub-e.eps
Press the [MENU] button to access the menu screen.
Use the [ ] [ ] buttons to choose “LINE/PHONO
Input.”
Press the [ENTER] button to confirm your choice.
Use the [+] [-] buttons to change the value to select
“PHONO.“
* With the factory settings, this is set to Line.
If You’re Recording to an SD
Memory Card
If You’re Recording to a
CD-R/RW Disc
1 Turn on the power ( ☞ Page 21, 23) . 1 Turn on the power ( ☞ Page 21).
2
Insert the SD memory card
( ☞ Page 25).
2
Insert the CD ( ☞ Page 28).
3 Set the audio source to “SD.”
Press the [SD CARD] button so it’s lit.
fig.selectCD-e.eps
3 Set the audio source to “CD.”
Press the [CD] button so it’s lit.
fig.selectSD-e.eps
To the output jacks of
the record player
CD-2i: RCA phono type
Audio device: RCA phono type
Types of plugs that can be connected
RL
CD-2i_e.book 55 ページ ２０１０年３月１５日 月曜日 午前１０時１５分