19
E-09
CHECKING THE VERSION
NUMBER
1. Hold down the [WORLD 1] + [SPRIT] + [KEYBOARD TOUCH] buttons,
and turn on unit's power.
* Hold down the three buttons until the following message appears.
The CPU and ROM version numbers will be displayed.
2. Please turn off the power, if the version of CPU and ROM is checked.
fig.lcd-ver
USERS DATA SAVE AND
LOAD
Required Equipment
• SMF Player
• MIDI Cable
SAVING DATA
This backs up (saves) all settings on the E-09 to an external MIDI sequencer.
Procedure
1. Use a MIDI cable to connect MIDI OUT on the E-09 to MIDI IN on the
sequencer.
2. Press the [FUNCTION] button to make it light up.
3. Use the [FAMILY < ] and [FAMILY > ] buttons to choose “UTILITY”.
Note: The LCD screen immediately after selection automatically
changes to [LCD Contrast].
4. Use the [SELECT < ] and [SELECT > ] buttons to choose “Bulk Dump?”.
fig.Save-01
5. Press the [TEMPO + / YES] button.
fig.Save-02
6. Start recording on the receiving sequencer.
7. Press the [TEMPO + / YES] button a second time.
fig.Save-03
8. When “Completed” is displayed, the operation is finished.
Approximately 2 seconds after [Completed] is displayed, the usual [001
St.Piano 1] screen appears.
Stop recording on the sequencer.
CPU1.00 ROM1.00
To Next Page
Loading...
