Roland E-09 - Song Functions; Recording Your Own Performance; All and Keyboard Recording Modes

20
JAN.2006
LOADING DATA
This restores backed-up data from the sequencer to the E-09 unit.
Procedure
1. Use a MIDI cable to connect MIDI IN on the E-09 to MIDI OUT on the
sequencer.
2. Switch on the power to the E-09. Perform no other operation.
3. On the sequencer, play back the file to load.
Do not operate the E-09 while data is being received. “Receiving” is displayed
while receiving is in progress. The E-09 automatically starts processing on
receiving the file.
4. When file playback ends, loading is finished.
FACTORY RESET
How to Perform a Factory Reset.
This returns all data stored on the E-09 to its factory defaults.
Any important data that has already been created and saved on the E-09 unit is
lost completely when a factory reset is performed. When you wish to keep
such data, save it using an external sequencer. (Refer to the sections on saving
and loading data.)
Procedure
1. Press the [FUNCTION] button to make it light up.
2. Use the [FAMILY < ] and [FAMILY > ] buttons to choose “UTILITY”.
* Stopping the operation when “UTILITY” has been selected makes the LCD
screen displayed change to “LCD Contrast”.
3. Use the [SELECT < ] and [SELECT > ] buttons to choose “Factory Reset”.
fig.factory-01
4. Press the [TEMPO + / YES] button.
fig.factory-02
5. Press the [TEMPO + / YES] button a second time to execute.
fig.factory-03
6. When the factory reset is finished, “Completed” is displayed on the
screen.
Approximately 2 seconds after “Completed” is displayed, the usual [001
St.Piano 1] screen appears.
Factory Reset?
Sure?
Executing..