3 Replacement of Main Parts
61
3
Fix the Screw2 temporarily.
10
11
Tighten up the Nut2 so that there is no gap between the
Frame and the Nut1.
Nut2
Screw2
Nut1
Frame
Screw1
9
Tighten up the Screws as the figure for fixing the Junction
Board Base.
Junction
Board
Base
Screws
Be careful the Limit SW. It is possible to break it
when you put the Junction Board Base.
<X Belt Tension Adjustment>
Nut2
Screw2
Nut1
Frame
Screw1
When fixing the X Belt, be careful not to overlap
the both end of the Belts.
X Belt
Belt Holder
To Next Page
Loading...
