Roland FP-9 - Switching the Power on and off; Adjusting the Sounds Volume and Brilliance

Switching the Power On and Off
Be sure to follow the steps below when turning the power on or off.
If
this
is
not
done
in
the
correct
sequence,
you
risk
causing
a
malfunction,
and/or
damage
to
speakers
and
other
equipment.
Turning On the Power
Front Panel
Speaker Line Out
folume Volume
Min, Max Mn Max
1. Before you switch on the power, adjust the [Speaker Vol-
ume] and [Line Out Volume] knobs to Min (minimum).
2. Connect the supplied power cord to the AC inlet on the
back of the unit.
3. Plug the supplied power cord into an AC outlet.
4. Press the [Power] switch on the back of the unit.
After a few seconds, the unit will be operable, and playing
the keyboard will produce sound.
Turning Off the Power
1. Before you switch off the power, adjust the [Speaker Vol-
ume] and [Line Out Volume] knobs to Min (minimum).
2. Press the [Power] switch on the back of the unit.
Rear Panel
aa. On (Turning on the power)
5. Use the [Speaker Volume] knob to adjust the volume
level. (See “Adjusting the Sound’s Volume and Bril-
liance” below.)
This unit is equipped with a protection circuit. A
brief interval (a few seconds) after power up is
required before the unit will operate normally.
Be sure to use only the power cord supplied
with the FP-9.
The power is switched off.
& Off (Tuming off the power)
Adjusting the Sound’s Volume and Brilliance
Speaker Line Out -
‘olume Volume Brilliance
cee “Cy
e 4 ©) ° °
Min Max Min Max = Mellow Bright
1 2
1. Use the [Speaker Volume] knob to adjust the overall vol-
ume level.
Turning the knob toward Max increases the volume, and
turning it toward Min lowers it.
2. Use the [Brilliance] knob to adjust the overall sound
quality.
Turning the knob toward Bright makes the sound more
brilliant, and turning it toward Mellow makes it more
restrained.
1