Roland G-800 - Song Set

Disk mode, Song Set
LL
LL
a
aS
Se
SSS
SSS
SSS
SRS
SSG
ss
AD
Song Set
Songs Sets are similar to User Style Sets in that they, too, only consist of references to Songs
on the same disk. Song Sets allow you to program the playback sequence of a programmable
number of Songs. Combined with “Song Set Play” on page 29, Song Sets can either be used
to entertain the audience while you are taking a break, or to assist you while performing with
Standard MIDI File backing.
SngSet Position Disk Sang
12 A hight in Tuni
© Master page: [F5] (Disk)—> [SHIFT] + [F2] (SngSt)
m Sng Set
This
parameter
allows
you
to
select
an
existing
Song
Set
for
editing
(e.g.
to
add
Songs,
change their order, or shorten the Song Set).
E New
Press Part Select [M.DRUMS] to create a new Song Set.
E Position
Use this parameter to select the place in the chain you wish to assign a Song to. For new Song
Sets, you cannot select the Position. Instead, assign a Song to the first Position.
E Disk Song
Allows you to assign one of the Songs on disk to the inverted Position. When you assign a
Song to a Position, the #+Ernghe event automatically jumps to the next Position in line
(i.e. a new Position is inserted). Again assign a Song to the “End” event, etc. To shorten an
existing Sonng Set, select ***End*** instead of the Song name for the Position following the
Song that is to become the last one of your Song Set.
M Save
Press Part Select [UPPER1] to save the Song Set to disk.
Note: You cannot name Song Sets, so be sure to remember their numbers.
103