Roland G-800 - User St\Copy\.20: 1 Page. Unida Ti Cta Ioirik Ae Aa EEES a

User Style mode, Track Copy
A. (q TT A a
CPT
This is where you specify the CPT position of the beginning and end of the pattern to be cop-
ied. Unless you do not need all notes within the last bar, you should leave the default setting.
Mode (Replace, Merge)
Selects the Copy mode:
Copy mode Explanation
ne
The data in the selected range will be copied to the destination track and over-
write all data (of the destination track) in the selected source track range.
The data in the selected range will be added to any existing data on the desti-
nation track.
Replace
Mix
In
either
case,
the
length
of
the
destination
track
may
change
to
include
all
data
of
the
source
track.
In
other
words,
you
may
find
that
the
destination
track
is
longer
after
executing
the
copy
function.
Therefore...
Note:
If
the
User
Style
memory
you
wish
to
copy
to
already
contains
data,
save
it to
disk
before
copying.
The
G-800
has
no
Undo
function.
Saving
a
Style
to
disk
before
copying
will
allow
you
to
load
the
previous
version
in
case
something
goes
wrong.
User Stl\Copy\ To 1 page
a)
(2)
(3)
(4)
(5)
(6)
COPY j
HubE
I 1
` Da ` - ` G ka
-@- -@- -¢- -3
Ca ` e ~ e ki i
Master page: [F4] (UsrStl) > [SHIFT] + [F1] (Copy)
[PAGE] A/V (select To 1)
This page allows you to select the address the selected source pattern is to be copied to (the
destination pattern). Please be aware of the following restrictions:
1ADR patterns can only be copied to 1ADR tracks.
2ABS patterns can only be copied to 2ABS tracks.
AC
track
(e.g.
3AC1-8AC6)
can
be
copied
to
any
AC
track
—
but
never
to
a
IADR
or
2ABS
track.
Looped patterns cannot be copied to one-shot patterns.
Intros
can
only
be
copied
to
Intros,
Endings
only
to
Endings,
and
Fill-Ins
only
to
Fill-
Ins.
If
the
destination
track
or
pattern
Division
is
set
to
a
“forbidden”
value,
the
G-800
auto-
matically
selects
the
corresponding
source
value.
For
example:
if
you
selected
a
1ADR
track
as
source
and
the
3AC1
track
as
destination,
the
G-800
automatically
selects
“3AC1”
as
source
track.
Track, Mode, Type, Division
See page 52 for details.
Style
Selects
the
destination
User
Style
memory.
Only
User
Style
memories
can
be
selected
here.
53