Roland G-800 - Param\Cntrl\4 page: Expression pedal; Param\Cntrl\5 page: Extra Bender Controller

|
| G-800 Reference Manual
Param\Cnitrl\4 page: Expression pedal
a Far Status Down Up PARAM
1 r
a + (a ` r s *
-0- © -0- -0-
x ` + ` + `
a EXPRESSION PEDAL
i
>
Master
page:
[F2]
(Param)=>
[F3]
(Cntr!)
[PAGE]
A/V
(select
page
4)
Part
i The first parameter on this page is used to select the Realtime (UP1, UP2, LWR, MBD, or
MDR) or Arranger part (ADR, ABS, AC1~AC6) whose Expression settings you wish to edit.
j Note: There is no need to set these parameters if you don’t have an EV-5 or EV-10 Expression
pedal connected to the EXPRESSION PEDAL jack.
Status Realtime part & Arranger parameter)
Select “ri if you wish to control the selected part’s volume by foot, or OPF if you don’t want
the selected part’s volume to change whenever you use the Expression pedal.
Up (0~127)
\ The value you set here is the Expression volume (CC1 1) value that the selected part will have
| whenever the Expression pedal is closed (minimum setting). In fact, this parameter duplicates
the function of the knob at the left side of an EV-5, for example.
Down (0~127)
The value you set here represents the maximum volume you can achieve for that part by fully
| depressing the Expression pedal (maximum setting).
Note: It is perfectly possible to set the Up value to “127” and the Down value to “0”, so that the
corresponding part will only sound when the Expression pedal is up (closed).
Param\CntrN\5 page: Extra Bender Controller reaime pans)
This display page is entirely devoted to the Extra Bender settings. Before explaining the
parameters, we’d like to draw your attention to the fact that you can set the Value of several
available parameters, so that the Extra Bender allows you to control several parameters simul-
taneously. Therefore, do not forget to scroll through all the options and set their Value to zero
| to turn off the Extra Bender function for the selected Realtime part.
Fat
—
Parameter
—
Value
EZIAN
1
i
I
=
E
a
E
-@-
scntrl
4
ee
nae
mee
“EXTRA BENDER CONTROLLER — |[EEXit