Roland G-800 - Bielas; A a L

Mixer mode, Mixer\Effect pages
Chorus page
— Macro — Parameter — Value
-Pre-LPF
i $
CHORUS
> Master page: [F1] (Mixer)> [F4] (Effct)
Effect: [PAGE] A/F (select page 2)
E Macro
Chorus broadens the spatial image of the sound, adding richness. You can choose from 8
types of Chorus.
Chorus1,
Chorus2, These are conventional Chorus effects that add spaciousness and depth to the
Chorus3, sound.
Chorus4
Feedback ao eo a ; ae
Chorus This is a Chorus with a flanger-like effect and a soft sound.
E "4 . + . e .
Flanger This is an effect sounding somewhat like a jet aeroplane taking off and landing.
Snort Delay This is a Delay with a short Delay time.
Short Delay (FB) | This is a short Delay with many repeats.
Note: Seeing that Delay usually only works for one part, use the dedicated Delay for echo effects.
That way, the Chorus effect can be used to fatten the stereo image.
NH Chorus parameters
(a) Cho Pre-LPF (0-7)
A low pass filter can be applied to the sound sent to the Chorus to cut the high frequency
range. Higher values will cut more of the high frequencies, resulting in a more mellow Chorus
sound.
(b) Cho Level (0~127)
This parameter sets the overall volume of the Chorus effect. If only one Tone contains too
much Chorus, reduce its Chorus Send value (see page 15) rather than the Cho Level value.
(c) ChoFeedback (0-127)
This parameter sets the level at which the Chorus sound is re-input (fed back) into the Chorus.
By using feedback, a denser Chorus sound can be created. Higher values result in a greater
feedback level.
(d) Cho Delay (0-127)
This parameter sets the Delay time of the Chorus effect. Higher values will cause greater
deviation in pitch of the Chorus sound.
(e) Cho Rate (0-127)
This parameter sets the speed (frequency) at which the Chorus sound is modulated. Higher
values result in faster modulation.
19