Roland G-800 - Param\Glbal\5 page

Parameter mode, Param\Gibal\5 page
Param\Glbal\5 page
> Master page: [F2] (Param)> [F1] (Glbal)
[PAGE] A/V (select page 5)
Acc Wrap: Part and Range
As explained in the Player's Guide, the Wrap parameter is used to change playback of the
selected music Style so that all notes of a given bass line, etc. sound in a natural range. In
Natural mode, the Arranger transposes all notes that are too low or too high for the (usually
automatically) selected sound one octave up or down. Though useful in most situations, that
may result in accompaniment patterns that suddenly jump to another octave when you go
from G to F7, for example.
E Part (ABS, AC1~AC6) (Arranger parameter)
Use the Part parameter to select the part whose Range setting you wish to change.
NW Range
Range | Meaning
The Arranger sounds all notes of the part in question in a range that is natural
Natural for the Tone assigned to that part. Notes that are too high or too low are trans-
posed down or up.
| In this case, the notes of the accompaniment track are played the way they
Full were programmed. That may be useful when you use the User Style function
for sequencing purposes.
Song Set Play
The Song Set Play functions allow you to specify how the selected Song Set (see page 103)
should be played back.
E Mode (Auto, Manual)
Select Auto if playback of the next Song in line is to start automatically after the Pause time
has elapsed (see below). Select Manual if you wish to be in control of when the next Song is
played back.
EH Pause (0-99 seconds)
The Pause value specifies the blanks between two Songs of a Song Chain. Note that the Pause
value is only used when you set Mode to Auta.
9aQ