Roland G-800 - Source\Tune page

G-800 Reference Manual
Value
This is where you set the value of the currently displayed parameter. As explained above, you
can set the Value of all available (but currently invisible) parameters.
Source\Tune page
‘Tune Scale UPIPort UP2Port]
EChitr 1
Le mee mem ee
PERFORMANCE MEM SONG SELECTION |EEXit p
D Master page: [F2] (Param)=> [SHIFT] + [F2] (Tune)
As explained in the Player's Guide, the Source switches allow you to protect your Param set-
tings from data coming from the Standard MIDI File you are playing back using the G-800’s
Recorder. The fact that only Fr" and 5112 are selectable is a clear indication that all Source
switches, except the MTune switch, apply only to the Realtime parts.
Source switches
Seeing that all Source switches on this page work the same, we will discuss them together.
Select Fr-f if the respective parameters must not change in response to MIDI messages of
that type contained in the Standard MIDI File you are playing back with the internal Record-
er. Prf means that either your own settings or the settings of the selected Performance Mem-
ory will be used.
Zrna means that the respective MIDI messages contained in the Standard MIDI File may
change the parameter(s) in question.
Source Meaning
MTune The Master Tune setting (see page 30).
UP2Tune The Coarse and Fine settings of the Upper2 part (see page 31).
f f ;
Scale ' Tuning values of the Kod Scale function (see page 31),
UP1Port | The Portamento Time value for the Upper1 part (see page 32).
[i
UP2Port | The Portamento Time value for the Upper2 part (see page 32).
no