Roland G-800 - Parameter\Global\2 page

Parameter mode, Parameter\Global\2 page
You
do
not
need
to
load
all
settings
of
Performance
Memory
00
if
there
are
parameter
values
you
do
not
wish
to
overwrite.
Settings to be loaded | Meaning
Tone
Only
Tone
selection
of
Performance
Memory
00
will
be
loaded.
Mixer
Only
the
Mixer
settings
of
Performance
Memory
00
will
be
loaded.
Dynamic
Arranger
Only
the
Dynamic
Arranger
settings
will
be
loaded.
Param | Only the settings of the Parameter level will be loaded.
All All settings of Performance Memory 00 will be loaded.
Cursor Character (Performance Memory parameter)
These
two
“parameters”
are
used
to
name
or
rename
the
currently
selected
Performance
Memory.
The
available
characters
are:
tou
ABCOEFGHIJELMHOPGRSTUUMRY?
aboder2ahidk EA ea hou yw r
Parameter\Global\2 page
Salk “UPzSplit $ « CPT Ip
an
ES
486
I i = THF
na
a Snte 1
FILLAM TEMPO CHANGE |EEXit.
> Master page: [F2] (Param)> [F1] (Glbal)
[PAGE] A/V (select page 2)
Split (C3~C6) (Realtime parts, Arranger parameter)
This parameter specifies the split point between the Right and Left sections of the Arranger
and the Split Keyboard Mode. It can be set from C3 to C6. Default value is C4.
UP2Split (C#3~C#6) (Realtime parts)
This
parameter
specifies
the
split
point
between
the
Upper!
and
Upper?
sections.
It
only
takes
effect
when
the
indicator
of
the
[UPPER2
SPLIT]
button
lights.
The
Upper2
split
point
can
be
set
anywhere
between
C#3
and
C#6.
Default
value
is
G5.
Fill Rit (15%~90%) (Arranger parameter)
This
parameter
defines
the
intensity
of
the
ritardando
achieved
during
playback
of
a
fill
(To
Original
or
To
Variation).
Note
that
Fill
In
Rit
only
applies
to
fills
and
that
the
[FILL
RIT]
indicator
must
light
for
the
ritardando
to
be
executed.
aaa
25